TECO TPO47CFAM, Owner'S Manual, Page: 9 / 22

7
OPERATING INSTRUCTIONS
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons "+" or " - " to
select your desired room temperature. The
temperature can be set within a range of
O O O O O
17 C-30 C/62 F-88 F (or 86 F).
- Press the "FAN SPEED" button to choose the
fan speed.
Operating Instructions
COOL operation
FAN operation
-
When you set the air conditioner in
AUTO mode, it will automatically select
cooling, heating(cooling only models
without), or fan only operation depending
on what temperature you have selected
and the room temperature.
- The air conditioner will control room
temperature automatically round the
temperature point set by you.
- Under AUTO mode, you can not select
the fan speed.
9
FOLLOW ME/TEMP SENSING feature
To activate the Follow Me/Temp Sensing
feature, point the remote control towards
the unit and press the Follow Me/Temp
Sensing button. The remote display is
actual temperature at its location. The
remote control will send this signal to the
air conditioner every 3 minutes interval
until press the Follow Me/Temp Sensing
button again.If the unit does not receive
the Follow Me/Temp Sensing signal during
any 7 minutes interval, the unit will beep to
indicate the Follow Me/Temp Sensing mode
has ended.
NOTE: This feature can be activated from the
remote control ONLY. The remote control serves
as a remote thermostat allowing for the precise
temperature control at its location.
- Press the "MODE" button until the
"FAN " indicator light comes on.
- Press the "FAN SPEED" button to
choose the fan speed. The temperatur
e
cannot be adjusted.
- Do not put the duct to window.
TIMER operation
- When the unit is on, press the
Timer button will initiate the Auto-off stop
program, the TIMER OFF indicator light
illuminates. Press the UP or down button to
select the desired time. Press the TIMER
button again within 5 seconds, the Auto-on
start program is initiated. And the TIMER
ON indicator light illuminates. Press the up
or down button to select the desired Auto
on start time.
- When the unit is off, press the Timer
button to initiate the Auto-on start
program,press it again within five seconds
will initiate the Auto-off stop program.
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours. The
control will count down the time remaining
until start.
- The system will automatically revert back
to display the previous temper
ature setting
if there is no operation in a five seconds
period.
DRY
operation
-
Press the "MODE" button until the "DRY"
indicator light comes on.
-
Under this mode, you cannot select a fan
speed or adjust the temperature. The fan
motor operates at LOW speed.
AUTO
operation
-
Keep windows and doors closed for
the best dehumidifying effect.
-
Do not put the duct to window
-
Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop timer
program.
-
When the malfunction (E1,E2,E3 or E4)
occurs, the Auto Start/Stop timed
program will also be cancelled.
(not applicable)