TECO F33 Series, Instruction Manual, Page: 22 / 192

Installation 19
3.4 Cable specifications
3.5 Stripping lengths
Fig. 27 indicates the recommended stripping lengths
for motor and mains cables.
Fig. 27 Stripping lengths for cables
3.5.1 Dimension of cables and fuses
Please refer to the chapter Technical data, section
14.6, page 160.
3.5.2 Tightening torque for mains
and motor cables
Table 7 Cable specifications
Cable Cable specification
Mains
Power cable suitable for fixed installation for the
voltage used.
Motor
Symmetrical three conductor cable with concen-
tric protection (PE) wire or a four conductor cable
with compact low-impedance concentric shield
for the voltage used.
Control
Control cable with low-impedance shield,
screened.
Table 8 Stripping lengths for mains and motor cables
Model
Mains cable Motor cable
a
(mm)
b
(mm)
a
(mm)
b
(mm)
c
(mm)
0003-0018 90 10 90 10 20
0026–0046 150 14 150 14 20
0060–0073 130 11 130 11 34
0090-0175 160 16 160 16 41
JNFX48-
0210–0250
JNFX69-0090-
0175
170 24 170 24 46
(06-F45-cables only)
Motor Mains
Table 9 Model JNFX48/52 0003 to 0046
Brake chopper Mains/motor
Tightening torque, Nm 1.2-1.4 1.2-1.4
Table 10 Model JNFX40/50 0060 to 0073
All cables 60 A All cables 73 A
Tightening torque, Nm 1.5 3.2
Table 11 Model JNFX48 0090 to 0109
Brake chopper Mains/motor
Block, mm
2
95 95
Cable diameter, mm
2
16-95 16-95
Tightening torque, Nm 14 14
Table 12 Model JNFX48 0146 to 0175
Brake chopper Mains/motor
Block, mm
2
95 150
Cable diameter, mm
2
16-95 35-95 120-150
Tightening torque, Nm 14 14 24
Table 13 Model JNFX48 0210 to 0250 and JNFX69 0090
to 0175
Brake chopper Mains/motor
Block, mm
2
150 240
Cable diameter, mm
2
35-95 120-150 35-70 95-240
Tightening torque, Nm 14 24 14 24