Tecnoware ERA LED 0.65, User Manual

Page: 15 / 19

UPS ERA LED 0.65 – 0.85 – 1.1 13 User’s manual
Risk of electric shock: do not remove the cover. The UPS contains internal parts that are
at a high Voltage and are potentially dangerous, capable of causing injury or death by
electric shock.
There are no internal parts in the UPS that are user serviceable. Any repair or
maintenance work must be performed exclusively by qualified technical personnel
authorized by TECNOWARE.
TECNOWARE declines any responsibility if this warning is disregarded.
Warning to the technical personnel authorized for service: since internal components
are connected to the batteries, they will remain powered, and therefore dangerous,
even after the UPS has been disconnected from AC power mains. Before any repair or
maintenance work, disconnect the batteries, by removing the positive cable (red colour)
from the positive pole of the battery.
ANOMALY POSSIBLE CAUSE ACTION TO SOLVE
The UPS does not
turn on
ON/OFF button Press the ON/OFF button and check that is pushed.
Batteries are flat Recharge the batteries for at least 4 hours.
Electronic board failure Refer to Technical Service.
The UPS always
function on
Battery mode
Input mains power cable
is disconnected.
Check the input mains power cable.
Check the presence of the electrical mains.
Input mains fuse is burnt Replace the fuse with another of the same type.
Black-out conditions /
surge/ Over-Voltage or
Low-Voltage
Wait until the AC Input Line returns to normal conditions.
Electronic board failure Refer to Technical Service.
Battery Autonomy
is too short
Battery is not fully
charged.
Recharge the battery for at least 6 hours.
Electronic board failure Refer to Technical Service.
“OVERLOAD” alarm “OVERLOAD” condition Disconnect all devices that cause the overload condition.
“FAULT” alarm “FAULT” condition
Check if UPS is in OVERLOAD condition.
Refer to Technical Service.
The UPS does not
communicate with
the Computer
The UPS Management
Software sends a
communication error
Check that the USB (or RS232) cable is correctly connected
between the UPS and the Computer.
The Software is not
correctly installed Install correctly the specific Software for your Computer’s
Operative System.
If the described anomalies should continue despite the advised troubleshooting, or should they
manifest in any other form, please contact:
TECNOWARE SERVICE
www.tecnoware.com