Tecnospiro 3arm 2 Series, Instructions & Operating

Page: 9 / 26

OARM and HEADMEMBER SELECTION
INSTALLATION
1. Attach the machine base plate to the work table by means of three M8 screws or a
clamp.
2. Fit the radial arm into the base axis, tighten the 2 Allen M5 and cover them with the
two plastic caps.
WORK WITH HIGH PIECES
Hold the base casing, pull it up and turn it 90º to fix it. The machine will be 130 mm higher,
and now it is ready to work.
ARM BALANCE
Regulating the internal strain damper different weights at the arm end are balanced.
•
Using an ALLEN key of 5mm, take up or let down the thread regulating shank (1)
located in the lower part of the cross unit.
o
Down (turn left): More strain to the damper.
o
Up (turn right): Less strain to the damper.