TECNOPLAST ITALY Srl Pag.10
INFORMATION ON RESIDUE DANGERS AND EMERGENCY SITUATIONS
Big attention is dedicated during design, production and delivery of any equipment, to point
and prevent any possible risk for operator’s health.
It is inevitable the presence of residual risks not foreseeable through design or protection
devices, or potential and not apparent dangers. Here is a brief list of the most significant .
Stability
Shapes, materials and anchorage structures are designed to guarantee
maximum stability when adverse meteorological conditions occur – wind, snow,
hail. Avoid to overload the external parts with foreign bodies, to not
compromise stiffness and strength, or cause breakage or deformations.
Risks due to surfaces, angles and edges
Being realized having care to round off any angle and edge, some equipment
parts could cause injuries or abrasions in case of impact or rubbing. During
manual movement it is recommended to wear protection gloves.
Risks due to assembling errors
The present instruction manual is thought to ease and make safer the
assembling and start-up operations. It is recommended to read it carefully
because malfunctioning, breaks, accidents can derive by their underestimation.
In case of doubt read again the interested parts or consult directly the
TECNOPLAST Italy Srl technical personnel.
Fire risks
The equipment is designed and produced to avoid any fire risk or overheating
caused by itself. Being partially realized in plastic material – inflammable, if not
self-extinguish version -, some elementary fire-proof cautions must be taken.
Avoid to install the equipment near heat sources and to produce flames
(oxyhydrogen torch or matches and cigarettes) in proximity of it. Check the
electric connections quality to prevent sparks and discharges.
Fall risk
Fans can be located on roofs, metallic or cement structures. The fall risk is
always present during shifting, lifting, positioning, installation and maintenance
and cautions must be always taken.
ASSEMBLING AND DISASSEMBLING
With reference to the exploded fan view, the disassembling must be executed with this
procedure.
1.
IMPELLER SUBSTITUTION OR CLEANING
a)
Disconnect ducts
b)
Disconnect electrically the motor (3)
c)
Unscrew the casing fixing nuts (13)
