![Tecno Air System ASOLO Operating Instructions And Safety Instructions Download Page 15](http://html.mh-extra.com/html/tecno-air-system/asolo/asolo_operating-instructions-and-safety-instructions_1071645015.webp)
TecnoAirSystem
Do not refuel/refill during operation. Always follow the instructions for correct
supply.
Hot surfaces, do not touch the burner during operation and immediately after use!
Do not refuel/refill during operation!
The external parts of this fireplace becomes hot while it is operating and remain hot
for a while even after it is switched off. Keep minors and pets out of reach until the
equipment cools down.
Do not store flammable materials near the fireplace.
Use the special included accessories to adjust /turn off the flame.
GUIDE TO SOLVE SMALL PROBLEMS
The fireplace will not start:
Verify that the lighter work properly, the bioethanol level is too low and lighter not
get to fire.
Check the fuel level.
Fuel is not suitable. Use only Bioethanol Ecofire or equivalent.
Smoke comes out:
Fuel is not suitable, or extraneous flammable material presence inside the burner or
in the fireplace. Immediately turn off the fireplace and contact a service center
Flame extinguishes:
Bio-ethanol is not enough, wait until the fireplace has cooled down, and proceed to
fill to the correct level of bio-ethanol.
The regulator control flame is excessively closed.
Flame spreads outside the tank:
Overfilling of the tank, the liquid is leaking, turn off the fireplace with regulator
slider and allow remaining flames to exhaust and make sure that the flames can not
propagate surrounding.
Wait for the fireplace to cool down and check it if there is overflowed fuel.
The protection glasses become black:
It is normal, because the yellow flame touch the glass especially when we use on the
external places or under the wind.
Wait until the fireplace become cool, clean the glass with a specific glass cleaner.
Do not clean the glasses if is still hot, could be cause skinburn or glass breakage.
The burner become black:
It is normal, could happen because the heat and the flame touch the metal. Wait untill
the fireplace become cool and clean the soot with a soft dampened cloth.
Summary of Contents for ASOLO
Page 17: ...TecnoAirSystem ...
Page 18: ...TecnoAirSystem ...
Page 20: ...TecnoAirSystem Rev 0617 ...