Operation Manual
2.00
10
1.4 Connections
V Series
loudspeakers utilize Neutrik
®
SpeakON
®
connectors. There are two NLT4
connectors on the rear of each V Series enclosure. These connectors mate with Neutrik
®
NL-4
or NL-4 compatible in-line cable connectors. The pins 1+/1- of both connectors are wired in
parallel to link multiple loudspeakers on a single amplifier output. Remember that parallel
connection reduces the total impedance (Ω) seen by the amplifier.
The total impedance of loudspeaker connected in parallel must not drop below the
minimum operating impedance of the amplifier.
The following subsections describe the electrical connections of V-10, V-12 and V-15.
IN speakON
®
point
1+
1-
2+
2-
Connection
IN + IN - NC NC
The V Series uses the pin assignment 1+/1+.
Using one as the input, the second connector allows for direct connection to a second
cabinet.
Fig.1.- Wiring diagram
Summary of Contents for V Series
Page 2: ......
Page 26: ...Operation Manual www tecnare com V Series rev 2 00 25 ...
