Operation Manual
IBZA Series | rev.
2.00
11
2
Loudspeaker Configuration
2.1 Point Source
In this configuration the system operates over the nominal frequency range of the
enclosure.
IBZA6 enclosure is driven by the PA4.450, PA900 amplifier with the DP Series Processor or
T-44/T-48 Series amplifier controller both with factory preset.
IBZA6 Standalone mode
2.2 Point Source with low-frequency element
In this configuration, the frequency response of the IBZA6 is extended in the low end.
IBZA6 enclosure is driven by the PA4.450, PA900 amplifier with the DP Series Processor or
T-44/T-48 Series amplifier controller both with same factory preset as in point source
configuration. The subwoofer will be operating with its corresponding factory preset. The upper
frequency limit must be 110 Hz for an optimal acoustic coupling with the enclosure.
If your IBZA6 loudspeakers and subwoofers are separated by a greater distance - or delay
must be used between them - a measurement system such as
SMAART
should be used to
determine the correct delay and polarity.
Frequency Range (+/- 6dB)
82- 20Hz
