Read & Understand All Instructions Before Using
WARNING
WARNING
WARNING
Severe personal injury could occur if the user fails to follow the above
mentioned warnings, and/or fails to follow the operating instructions.
SAFETY WARNINGS - READ BEFORE USING
1
The auto-darkening welding helmets are designed to protect the eye and face from sparks,
spatter and harmful radiation under normal welding conditions. This auto darkening filter
will automatically turn on when pick it up. The filter automatically changes from a light
state to a dark state when an arc is struck, and it returns to the light state when welding
stops. This helmet are designed to be used together with Freflow V1 blower unit to protect
against airborne contaminants.
The Auto-Darkening welding helmet comes assembled. But before it can be used, it must
be adjusted to fit the user properly. Check battery surfaces and contacts and clean it if
necessary. Verify if the battery is in good condition and installed properly. Set up for delay
time, sensitivity and shade number for your application.
The helmet should be stored in dry, cool and dark area and remove the battery, when not
using it for a long time.
Inspect face seal for damage and replace if necessary. Make sure the air is supplied to helmet.
This Auto-Darkening welding helmet is not suitable for laser welding.
Never place this helmet and Auto-Darkening filter on a hot surface.
Never open or tamper with the Auto-Darkening filter.
This Auto-Darkening welding helmet will not protect against severe impact hazards.
This helmet will not protect against explosive devices or corrosive liquids.
Do not make any modifications to either the filter or helmet, unless specified in this
manual. Do not use replacement parts other than those specified in this manual.
Unauthorized modifications and replacement parts will void the warranty and expose
the operator to the risk of personal injury.
Should this helmet not darken upon striking an arc, stop welding immediately and
contact your supervisor or your dealer.
Do not immerse the filter in water.
Do not use any solvents on the filter screen or helmet components.
Use only at temperatures: -10°C ~ +55°C (14°F ~ 131°F).
Storing temperature: -20°C ~ +70°C (- 4°F ~ 158°F). The helmet should be stored in dry
cool and dark area and remove the battery, when not using it for a long time.
Protect filter from contact with liquid and dirt.
Clean the filter surface regularly; do not use strong cleaning solutions. Always keep the
sensors and solar cells clean using a clean lint-free tissue.
Regularly replace the cracked / scratched / pitted front cover lens.
The materials which may come into contact with the wearer’s skin can cause allergic
reactions in some circumstances.
Professional Quality
Welding Helmet
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
