13
Operation
Cooling mode
When the A/C enters cooling mode automatically or cooling mode is selected after it’s
turned on, the cooling indicator lamp lights up.
Press Up/Down key to adjust setting temperature (17
℃
~30
℃
).
Press Speed key to choose High/Low fan speed.
Fan mode
When pressing mode key or choosing fan mode by pressing the remote control, the wind
indicator lamp lights up, the unit will run under fan mode.
Press Speed key to choose High/Low fan speed.
Temperature cannot be set.
Auto- mode
Press mode key from control panel or choose auto-mode from remote control to enter auto-
mode. The indicator lamp will light up when under auto-mode.
After choosing auto mode, operation state is determined by ambient temperature: when
ambient temperature is higher than 25
℃
, the operation state is the same as that of cooling
mode; when it is lower than 25
℃
, the operation state is the same as that of fan mode.
Max cool mode (optional)
Under cooling mode press TIMER and UP buttons at the same time to enter Max. cool mode.
In Max. Cool mode, the A/C will cool in regardless of temperature restriction.
In Max. Cool mode, fan speed is high, and it can’t be adjusted.
Sleep mode (optional)
Press TIMER and DOWN button at the same time under cooling to enter sleep mode.
Under this mode, the set temperature increases by 1
℃
after the unit running for 2 hours,
and 2 hours later it’ll increase by another 1
℃
, after that it won’t change any more.
Under this mode, the fan blows at low speed and fan speed can not be adjusted.
Timer mode
In standby state, press the key to set TURN ON time. Press Up and Down keys to set TURN
ON time (0~24H), and the timer indicator lamp lights up.
Press timer key to set TURN OFF time when the unit is on. Press Up and Down keys to set TURN
OFF time (0~24H), and the timer indicator lamp lights up.
6. Drainage
This product is equipped with an evaporation system. The condensing water is used to cool the
condenser. This not only improves cooling but also saves energy for you.
• If it becomes too much condensate water in the apparatus,
the display will show “
FL
” and the compressor will stop
working.
• After power off, unscrew the water cover, pull out the
water plug to drain off water, and it will become normal
after being restarted.
After draining, you can turn it on and the device will work
again.
