Tecknet M001, User Manual

Page: 7 / 24

Specifications
Button Count: 3 buttons
Operating Frequency: 2.4GHz
Resolution: 1000/1500/2000DPI
Receiver interface: USB version 2.0
Operating Voltage: 1.5V
Operating Current: 6.8mA
Operating Distance: up to 10m
• Ensure that the Mouse is within the operational working distance
(ideally 1.5m) from the USB Nano Receiver and restart your PC.
• Increase the distance between the Nano Receiver and the base units
of other cordless devices.
• Turn off any cordless device and their base units that are near the
mouse Nano Receiver.
• If you are using the Mouse on a metal surface, move the Mouse and
the receiver to a non-metallic surface. Metals, such as iron,
aluminium or copper shield the radio frequency transmission and may
slow down the Mouse cursor’s response time or cause the Mouse to
Every effort has been made to ensure that the information and
procedures in this guide are accurate and complete, no liability can be
accepted for any errors or omissions and we reserve the right to make
any changes without further notice to any products mentioned herein.
We warrant that product from authorized distributors will meet the
applicable product specifications and be free from all defects in design,
assembly, material and workmanship. Please contact TeckNet retailers,
or visit www.tecknet.co.uk for more information about the product.
Troubleshooting
What do I do if the mouse does not work?
• Ensure that the polarity of the batteries is correct. The positive (+) and
negative (-) ends of each battery must match the positive (+) and
negative (-) markings in the battery housing.
• Make sure the batteries are not discharged.
• Remove the batteries and reinstall the batteries again.
• Verify that your computer's power management feature is turned off.
• Ensure the Nano Receiver’s USB connector is firmly attached to the
PC’s USB port.
The USB Nano Receiver is recognized by Windows
(Windows2000, 2003,XP,Vista,Win7,Win8,Mac10.x) but
the cursor does not move
• Check whether the low power indicator on the top of the Mouse keeps
flashing. If the sensor lights up, it is likely that the batteries are
discharged. Please replace them.
• If replacing the batteries does not help, it is likely that the Mouse is
not connected to the Nano Receiver. Please remove the Nano
Receiver and plug in again or remove the battery and re-install.
When I use the Mouse other 2.4G cordless devices work
more slowly or fail temporarily – what should I do?
• The mouse may cause interference with any cordless, radio-based
device that operates at 2402MHz - 2480MHz, such as a 2.4G
telephone, 2.4G baby monitors, 2.4G cordless routers and toys. To
reduce interference, move the Nano Receiver and the base unit of the
affected device as far away from each other as possible. Alternatively
try to change the 2.4G frequency of the affected devices.