ASSEMBLING
● Take the two base cross and push the end caps
into the ends. Cross them over together as draw :
● Remove the four screws from the base and pole
the base on the fix tube to the base.
● Screw the 4 screws in the feet
● Slide the screw cover down over the adjustable
and lower base until it’s hide the screws.
● Set the height of the feet
● Attach the motor fan + panel control on top of the
upper tube and tighten it with retaining screw.
● Place the rear guard (2) onto the motor housing (pass the axis (1) in the hole
at the centre of the grid) and fix it with Central Fixing nut (3), and screw it
clock wise.
● Slide fan blade (4) onto the motor
spindle ensuring that notch on the
rear line up with the spline on the
shaft.
● Screw on the Blade with the Retaining Nut (5) turning anticlockwise
direction.
● Hang the front guard over the top of the rear guard and push the clips
inwards until the front guard is fastened to the rear guard.
8
