3
Installation
Make sure the mounting surface is strong enough to hold at least three times of the
camera weight.
The following figure is for reference only, and the actual product shall prevail.
see Figure 3-2 and Table 3-2.
Figure 3-2
No.
Item
No.
Item
No.
Item
①
Device
②
Self-tapping screw
③
Bracket
④
Expansion bolt
⑤
Mounting surface
Table 3-2
Step 1 Drill screw holes (and the cable outlet hole if it needs to go through the mounting
surface) on the mounting surface
⑤
as indicated on the positioning map.
Step 2 Different approaches required according to different mounting surfaces.
For masonry mounting surface, insert expansion bolts
④
from the accessory pack
in the screw holes.
For wooden mounting surface, expansion bolts are optional.
Step 3 Adjust the location of the bracket
③
according to cable outlet requirement (top out or
side out), and then pull the cable out through mounting surface or the side cable tray.
Step 4 Align the screw holes on the bracket
③
to those on the mounting surface, then put in
and fasten the supplied self-tapping screws
②
to attach the device
①
to the mounting
surface.
Step 5 Connect the camera to power source and the XVR device, and then aim the lens to the
ideal angle, see Figure 3-3 or Figure 3-4.
