User’s manual
6
UPS ECO 0.50 – 0.70 – 0.90 – 1.1 – 1.3
4.2
Rear Side
Figure 2 – Rear Side
On ECO rear side there are (see figure 2):
1.
Grounded AC Input power socket:
IEC C14 type; to connect the UPS to the AC utility line.
2.
Input fuse:
electrical specification: max current 5 A, voltage 250 V.
3.
Grounded UPS Output receptacles:
IEC C13 type.
5
Electrical Installation and First Start Up
We advise you to follow the steps below explained for greater safety:
1.
Switch off all the devices (Personal Computer or other electronic devices) that need to be supplied by the
UPS.
2.
Connect the UPS Input socket to the AC line outlet through the Personal Computer supplying cable.
It is
mandatory to ground the AC line outlet according to the Safety Standards
. Carefully check the grounding,
make sure that the utility power is available, and that its range falls within the UPS specifications (refer to
the “Technical Characteristics” chapter).
3.
Press the
ON/OFF
button on the front panel for about 2 seconds until the UPS emits a brief acoustic signal.
The UPS turns on the leds the front panel and performs a
functioning SELF-TEST
. After some seconds the
UPS starts to work in
Normal mode
: the
LINE/BATTERY
led is on. Leave the UPS in Normal mode for at least
4 hours in order to completely recharge the batteries
1
2
3