Edition:10/14
7
Manual Storage Heater TTS with electronic control
GB
Output Control
A proportion of the stored heat will be radiated from the casing providing a low level of
background heat. Output can be increased by switching on the fan(s) whereby heat is
discharged from the low level outlet grille.
This is done at the room thermostat located on the wall facing the heater. If the thermostat is
provided with an "ON-OFF" switch for the fan(s) set this switch to "ON". Then turn the
thermostat knob to the desired room temperature indicated on the dial. Once set, the
thermostat will then keep the room temperature automatically at this level by switching the
fan(s) on and off accordingly.
Integral Thermostat
TTS storage heaters are designed to use an integral thermostat as an optional accessory.
This is often of advantage when retrofitting storage heat into existing buildings as it
eliminates the need for wiring between a wall thermostat and the heater.
The accessory kit comprises a side panel complete with pre-wired thermostat and rocker
switch assembly.
Care of the Storage Heater
TTS storage heaters are designed to require minimum maintenance. The surface (when
cool) can be cleaned with any "liquid" household cleaner.
Note - Do not use abrasive cleaners as these may damage the finish.
In those areas where considerable amounts of dust, dirt and/or fur are encountered, it is
recommended that the area behind and in front of the heater be vacuumed quite frequently.
The fan assembly and base compartment should be completely cleaned at least every three
years just before a heating season.
Electrical Shock Hazard
TTS heaters are supplied by more than one electrical circuit.
Be sure that all circuits are turned off before opening the heater case.
Service should only be made by competent, qualified personnel.