Installation and Operating Instructions Frost Guard FW 501
Feel good through warmth from electricity - www.technotherm.de
GB
must be so installed that any persons using the shower or bath do not come into
contact with it.
• The device may not be fixed on walls of plastic, synthetic material or other easily
flammable materials as for example wood, panels, paper or similar. By disregard it
can come to the fire risk!
• Important!
Do not insert any foreign objects into the appliance openings or do
not insert any objects into the heater!
Risk of injury
(electric shock) and damage
to the appliance! Never place any objects between appliance and wall.
• If the heater is to be connected with a plug, the plug must be easily accessible to
enable the mains plug to be disconnected as quickly as possible!
• If the supply cord is damaged, it must be replaced by the manufacturer or its ser
-
vice agent or a similarly qualified person in order to avoid a hazard. • The power
cable must not come into contact with the unit during heating operation. Do not
put the cable on or around the hot appliance and do not pull it over sharp edges
or bend it.
• Do not use the heater outdoors.
• The product is for household use only and not for commercial use.
• The appliance is not suitable for animal breeding purposes!
• Do not operate the heater with an extension-cord.
• Do not use this heater with a programmer, timer, separate remote-control sys
-
tem or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
• Attention! Even on the lowest setting level the unit is always ready for use. In
order to switch off the frost protector, pull out the power supply plug or turn off
the permanently installed disconnecting switch (e.g. automatic cut-out, installa-
tion switch etc.).
