-
REAR
1.
Power In
PartyBlaster! or ClubCat! is designed to plug into a 110 VAC receptacle and is
-
supplied with a 110 VAC USA powercon style plug. The unit can be configured to
work on other voltages. Please contact your dealer for details.
2.
Identification Model and series
3.
Serial Number And Manufacture Date Label
-
I, date that the unit was manufactured, as
well as its own unique serial number, which is needed for the warranty (removing this label
voids warranty).
See Labeling Requirements for more information.
4.
.
CDRH Conformance Label
-
Indicates that the PartyBlaster! or ClubCat! Laser
Projection System complies with the CDRH Center for Device and Radiological Health)
requirements governing laser products manufactured in the United States.
See Labeling
Requirements for more information
5.
ILDA IN/through DB 25
in and out for ilda signal from laser software DAC must be
connected
to DAC to provide ilda cable interlock or the system wil not start and if removed during
operation it will shut the system down and it would need to be restarted
6.
Non-Interlock Label
CDRH required non-interlock label. Exposure to laser light may occur if
panels are. removed. See Labeling Requirements for
more information
Located On top of projector
7.
Power Switch
When activated this switch supplies power to the laser system and lights up red
when power is on
8.
Rear emission indicator/
—
laser status
off indicates no power or all interlocks
are not satisfied
green
indicates all interlocks satisfied and ready to start
red
indicates emission is possible
9.
Remote Interlock Connector
must be connected to remote ESTOP to operate.
10.
Interlock key switch
Must be in
on
position for laser to operate and the
Key
is
NON
removable in the on position
11. Fans
Keep fans un obstructed and clean filters regularly
12.
Pangolin FB4 see Pangolin FB4 and pangolin quickshow manuals for more info
10
