Technoline WS 6750, User Manual

Page: 5 / 7


Press
“MODE”
to switch from time display to A1 display

Press and hold the key
“MODE”
for 3 seconds ,the flashing alarm time are shown

The hour display of the alarm time is flashing. Use “
+
“ und “
-
“ to select the hour.

Press
“MODE”
to confirm.

The minute
display of the alarm time is flashing. Use “
+
“ und “
-
“ to select the minute.

Press
“MODE”
to confirm.

Then press
“MODE”
to switch from A1 display to A2 display

The same setting as for A1.
Daily alarm on/off

When showing A1 alarm time, press
“-“ to activate the alarm 1 with alarm symbol showing.

Press
“MODE”
again cancel the alarm

When showing A2 alarm time, press
“-“ to activate the alarm 2 with alarm symbol showing.

Press
“MODE”
again cancel the alarm

A1 for alarm from Monday to Friday, A2 for alarm from Saturday to Sunday.
Information:

The clock automatically changes from set-up mode to time mode if no keys are pressed for
20 seconds.

The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below

Press the key “
SNOOZE/LIGHT
“, while the alarm sounds, to activate the snooze function.

If the snooze function is activated, alarm symbol is flashing.

The alarm repeat after 5 minutes.

The snooze function can be stopped by pressing any key.
12/24 hours mode
The time display can be in 12
（
AM/PM
）
or 24 hours mode.
°C/°F temperature display
The temperature display can be in °C or °F. Press the key
“-“
to switch between the mode.
Max./ Min. for the indoor/outdoor temperature and humidity
Press
“+”
for displaying of indoor/outdoor max./min. of temperature and humidity.
Temperature alert set-up

Press “
Channel
” to select the channel (CH1, CH2, CH3) if more than one outdoor sensor
are within reach.

Press and hold the key
“
-
” ，
in the area of outdoor , select ON/OF when flashing.

Press
“MODE” , the upper limit temperature is flashing, use “+” , “-“ to set the maximum alert
temperature.

Press
“MODE “, the lower limit temperature is flashing, use “+” , “-“ to set the minimum alert
temperature.