z
Press “ °C /°F” button (D4), on the Thermo Sensor unit, to select Temperature to be displayed in
Celsius mode or Fahrenheit mode.
Maximum/Minimum Temperature/Humidity recording function:
z
Press “IN MEN” button (B8) to show the maximum or minimum of indoor temperature/humidity.
Press “OUT MEN” button (B12) to show the maximum or minimum of outdoor temperature/humidity.
“
” is shown on the LCD if maximum temperature/humidity is shown.
“
” is shown on the LCD if minimum temperature/humidity is shown.
y
Hold “IN MEN” button (B8) or “OUT MEN” button (B12) for 3 seconds to clear the recorded
maximum and minimum reading.
Temperature Alert function:
z
Hold “ ALERT” button (B5) for 3 seconds to enter Temperature Alert setting, Temperature’s digits
flash.
z
Press “ +” (B7) or “-” (B11) button to select Indoor or Outdoor CH1, CH2 and CH3 temperature alert.
Press “ALERT” button (B10) to confirm the setting.
z
Press “ +” (B7) or “-” (B11) button to set the upper ”
” and lower “
” limit of the temperature.
Press “ALERT” button (B5) to confirm the setting.
z
Press “ ALERT” button (B5) to set the Temperature Alert function on or off ( “
” appears on the
LCD if this function is on).
Radio Controlled Clock:
z
After registered new channels or press “CHANNEL” button (B4) to stop scanning, the clock will then
scan the DCF time signal ( “
” flashes on the LCD ). Buttons will not function while scanning
for DCF or Thermo sensor’s signal unless they are well received or stopped manually.
z
The clock automatically scans the time signal at 3.00 a.m. everyday to maintain accurate timing.
For failed reception, scanning stops ( “
” on the LCD disappear ) and repeats again at 4.00
a.m. 5.00a.m. and 6.00a.m.
z
The clock manually scans the time signal by holding “ - ” button (B11) for 3 seconds. For failed
reception, scanning stops. ( “
” on the LCD disappear ).
z
Hold “-” button (B11) for 3 seconds to stop scanning when receiving DCF signal.
“
” flashes indicate now is receiving DCF signal
