Technogym ISOCONTROL, Service Maintenance Manual

Page: 67 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 9.4
9.2. USER MENU CONFIGURATION
It is possible to modify the stand by messages (up to a maximum of 3) and the following three
parameters:
•
Units of measurement (imperial or metric)
•
Number of repetitions used for defining the ROM value specific to the user
•
Duration (in seconds) of weight stack inactivity in rest position before a set is considered
complete.
To modify the stand by messages and the three configuration parameters, it is necessary to use a
specially configured TGS key (see paragraph 9.2.1. “Configuring the TGS key”).
1. Insert the specially configured TGS key into the reader.
2. Press the “+” key to confirm and safe the data, or press the “-” key to cancel the operation.
3. At the end, the machine enters the stand by state.
Remove the TGS key from the reader only after the "remove TGS key" has appeared
on the display.
9.2.1. C
ONFIGURING THE
TGS
KEY
To configure the TGS key, start the IsoControl Configurator application included in the Wellness
System 5.0. The following window appears on start-up:
For further information on the configuration, consult the Trainer Help 5.0. facility.