Technogym excite vario, User Manual

Page: 37 / 42

cont.
Technical
information
Vario Excite
Switching on and off
To turn 700 and 500 versions of the equipment
on, switch the switch to “
I ” position.
To turn the 700 SP and 500 SP versions on,
begin moving.
When switched on, a beep sounds and all the
control panel LEDs light up.
After a quick system check (reset), the
equipment is ready for use.
 
The message does not appear if the keys are disabled (see the Configuration Menu section
in the software part) so that exercises can be started only with the TGS key.
   
The message does not appear if the TGS key reader is not installed or if the use of the TGS
key is disabled (see the
Configuration Menu
section in the software part) so that exercises
can be started only with the control panel keys.
In this mode, the following functions are enabled:
- calculation of heart rate, if measured;
- reading of access codes for configuration menu (see the
Configuration Menu
section in
the software part).
Manufacturer and equipment
identification
Description of the equipment
Technical data
Accessories
Safety devices and notices
Place of installation
Moving the equipment
Levelling
Electrical connection
Connection to another device
Routine maintenance
Changing the fuses
Recharging the battery
Troubleshooting
Technical assistance
Storage
Disposing of the equipment
Switching on and off
Monitoring the heart rate
Ergonomic positioning
on the equipment