Technogym EXCITE Run 500, Service Maintenance Manual

Page: 118 / 234

RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 7.10
7.6. KEYBOARD DISASSEMBLY
Figure7.6-1
Carry out the operations described in
paragraphs: 7.1. “Display disassembly”.
1.
Disconnect the connector of keyboard.
With the display on a work bench:
2.
Use a sharp tool to lift up and detach a corner
of the keyboard
To assemble a new keyboard, with the display on
a work bench:
1.
Remove the backing film from the adhesive.
2.
Apply the adhesive part, starting from the
left and working toward the right, without
bending the keyboard.
3.
Insert the connector in the special slot on the
display and connect it to the display board.
4.
Remove the protective film.
When reassembling the keyboard, make sure that none of the keys are bent or remain
pushed in.
The keyboard assembly procedure can only be carried out once, because disassembly
damages the tracks and keys. After reassembly the display, check with the Key Board
Test manual the proper functioning of new keyboard, as descripted at the pharagaf:
6.3.2.1 “Man. Keyboard Test”.