7
8
4. USING Ceveron
®
MFU 500
FIRST-TIME USE
Remove the foam pad which is placed between upper and lower part of the
manifold for protection during shipment.
The power supply is already set to the voltage of your country. The output
voltage is set to 12 Volts and must not be changed.
Checking the desired output voltage
•
The In-Plug Power Supply as delivered together with Ceveron
MFU 500
is set to an output voltage of 12 V DC.
•
Check if the DC output voltage is set to 12 Volt
•
Should the output voltage accidentally be set to a different voltage, it has
to be changed before using it together with Ceveron
MFU 500.
•
Before changing the output voltage remove the In-Plug Power Supply
from the AC socket
•
Make sure that the In-Plug Power Supply is not connected to the
Ceveron
MFU 500.
•
Use an appropriate screwdriver to set the output voltage at the yellow
switch to 12 Volt.
•
Using higher voltages than 12 Volt will damage the pump inside the
Ceveron
MFU 500
•
Using lower voltages than 12 Volt will result in poor function of the pump
and of Ceveron
MFU 500.
Change the output voltage only
in a powered-down condition!
Pay attention to the operating
voltage of 12 Volt! Likewise, pay
attention to the firm engagement of the
switch into the respective
voltage
position!
Summary of Contents for Ceveron MFU 500
Page 1: ......
