TechniSat
®
VC 2002 S
5
REMOTE CONTROL
TechniSat
TUNING
CH
An/Aus
M
AUDIO
MONO/ST
A/B
STORE
ERASE
1
2
3
4
5
6
7
8
9
0
W/N
V/H
DEV.
DECODER
D.MODE
POWER ON/OFF
MUTE
AUDIO UP/DOWN (FOR SUBCARRIER
FREQUENCY 5.0 - 8.80 MHz)
MONO/STEREO
A/B: LEFT/RIGHT STEREO (USED WITH AUDIO UP/DOWN)
DE-EMPHASIS (WIDE - TV-SOUND, NARROW - RADIO)
CHANNEL UP/DOWN
VIDEO FREQUENCY UP/DOWN (950-2050 MHZ)
KEY PAD
STORE
ERASE
DEVIATION HIGH/LOW BRIGHTNESS
V/H POLARISATION
DECODER (NORMAL/DECODER MODE)
DECODER SIGNAL SELECTION (D1-D4)
1. Connect the receiver VC 2002 S to the LNB of
the outdoor unit using a coaxial cable via IF-IN
connection.
CAUTION: Always ensure that the mains supply
is off when making any connections (including LNB
connection).
2. The connection between receiver and TV is
made using a scart cable. Alternatively, you can
make the connection using an antenna cable.
3. Connect the receiver to the mains supply
(240 V/50 Hz).
4. i) If you are using a scart cable connection, switch
your TV to AV.
ii) If UHF cable connections are being used it is
necessary to find a suitable UHF channel. The
satellite receiver is preprogrammed to channel
36. To set the TV or VCR to this channel select
TSG on the receiver back panel and search on
the TV until two vertical white bars are clearly
visible. If due to interference it is necessary to
adjust the UHF channel, this can be done using
the channel adjustment switch on the back of the
receiver (by turning the screw).
INSTALLATION & INITIAL OPERATION
