TechniSat DIGITRADIO CD 2GO, Instruction Manual

Page: 64 / 172

64
4.3.2 Connecting to a power supply
> Connect the supplied power supply cable to the socket labelled
DC-IN ( 5 ) on the side of the DIGITRADIO CD 2GO. Then connect
the USB plug to a commercially available USB socket or USB
power supply (not supplied).
When you connect the device to the mains for the first time,
" Welcome to Digital Radio " appears on the display. This will then
be followed by an initial station scan via DAB+.
4.3.3 Using the earphones
Hearing impairment!
Do not listen to the radio at a high volume with headphones. Doing so
can cause permanent hearing impairment. Turn down the radio volume
to the lowest volume before using headphones.
Only use headphones with a 3.5 mm jack plug.
> Insert the earphone plug into the
headphone jack
(
10
) on the
device.
The maximum volume is restricted as standard. If you want to
increase this limit, hold down the PRESET/EQ button ( 7 ) in CD
mode, or go to MENU (DAB mode). The setting is saved until you
turn the device off/on again.
> Set the volume you want using the volume knob ( 4 ).