TechniSat DIGITRADIO 586, Manual

Page: 72 / 160

72
> Change the value with the

or

buttons and then press OK .
This preset can be retrieved at any time in My EQ .
18.2 Internet settings
> Press the MENU button and then select [Main Menu > System Settings >
Internet Settings] .
In this menu you will find some settings and information about the Internet
connection.
> Select
Network wizard to establish a WLAN connection.
The network wizard shows you all the WLAN stations within range. Use
the

/

and OK buttons to select the WLAN network you recognise and
enter the password using the displayed keyboard. Then select and
press the OK button. If the password entered is correct, a connection to
the network is now established. The signal bars in the status bar of the
display indicate whether a connection exists.
To cancel the input, select and press the OK button. If you make a
mistake, you can delete the last letter you entered by pressing .
> If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WLAN network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press button] on the DIGITRADIO 586 after selecting the WLAN
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant button.
> If your router only supports the WPS PIN, select
[PIN]
on the DIGITRADIO
586 and take note of the PIN shown on the display. You then need to enter
the PIN in the router.
18.2.1 WPS connection
> Select [Internet settings > PBC WLAN set up ] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the - WLAN password.
How you activate WPS on your router can be taken from its instruction
manual.
> Start WPS on your router by pressing the relevant button. Note the
Instructions on the DIGITRADIO 586 display.