Yellow bar:
good reception
Green bar:
excellent reception
6 Operation
At the first time the receiver the receiver gets connected to the main supply the display
shows successively the symbols
dL, Iu
and
rA
. During this time the receiver checks if a
new operation software is available at the serial interface. If a new software is available the
receiver gets updated.
6.1 Switching on and off
>
Use the key
On/standby
on the receiver or on the remote control to switch the
receiver on.
>
Pressing the same key on the receiver or on the remote control again will switch the
receiver off again.
While the display shows
ird
, the receiver checks the last activated transponder if
there is a new irdeto software available.
>
After this procedure the receiver is in standby mode.
6.2 Programme Selection
6.2.1 Using the Programme up/down keys
>
Use the
Channel up/down
keys either on the receiver front panel or on the remote
control to move up or down the list one channel at a time.
6.2.2 Using the Numeric Key Pad
>
Use the numeric key pad to enter the desired programme/channel number directly:
For example:
1
Programme/channel
1
1
, followed by
4
Programme/channel
14
2
,followed by
3
, followed by
4
Programme/channel
234
When entering programme numbers consisting of more than one digit, you have about 3
seconds after pressing one digit to enter the next digit, in order to complete the entry in such
a way that the receiver recognises all digits as part of one selection.
If you are entering a programme number with only one or two digits, you can speed up the
selection process by pressing
OK
after entering the last digit.
6.2.3 Using the Programme List
>
Press the key
OK
A list of programmes will now be displayed.
18
bed_anl_DigiBox Irdeto_englisch.qxd 30.01.02 12:03 Seite 18
