Page 2
•
MN01047
Issue/Rev. 0.0 (10/18)
Depth Micrometer
Arbor Press
Slide Hammer Bearing Puller (651037-008)
Spider (for Checking Clearances):
– 2" – 556222-001
– 3" – 556223-001
Wood Block:
Feeler Gauges:
90° Feeler Gauges (0.001 to 0.010")
In-Line Feeler Gauges (.001 to .005")
General
To ensure the best performance of the Genesis Meter,
the step-by-step procedures outlined in this manual
should be followed. Review the entire manual prior to
disassembly or repair of the meter to fully understand
the requirements.
Reference Literature:
P0502.01 – Genesis 2" Parts List
P0505.01 – Genesis 3" Parts List
SS01060 – Genesis 2"/3" Specifications
MN01046 – Genesis 2"/3" Installation/Operation
Genuine Smith Meter Parts
The Genesis Meter is approved by several weights
and measures authorities. In order to maintain these
approvals, it is essential that all replacement parts are
Genuine Smith Meter Parts. This will provide the best
performance and quality.
Note:
The Genesis integral electronic calibrator is
matched by the meter serial number to provide the wide
range of performance characteristics. To comply with
weights and measures, replacement boards are required
to be ordered using the factory meter serial number
stamped on the nameplate.
Tools and Sealants/Lubricants
Tools:
3 mm Hex-bit Socket
4 mm Hex-bit Socket
5 mm Hex-bit Socket
6 mm Hex-bit Socket
8 mm Hex-bit Socket
1/4" Hex-bit Socket
5/16" Hex-bit Socket
3/8" Hex-bit Socket
17 mm Combination Wrench
17 mm Hex Deep Well Socket (2" meter)
24 mm Hex Deep Well Socket (3" meter)
Soft-headed Mallet
Torque Wrench:
– 40 to 250 in-lb
– 45 to 160 ft-lb range
Dial Indicator (thousandths of an inch)
Dial Calipers
Section I – General
Figure 1 – Feeler Gauges
Figure 2 – Feeler Gauges
13-3/4"
3"
