Technika DX6SS-6, User Manual

Page: 11 / 42

PG 11
Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only one single work
top under which cabinets and electrical appliances are
fitted. In this case remove the work top of the dishwasher by
unscrewing the screws under the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed
again under the rear edge of the top (b).
The height will then be reduced to 815 mm, as scheduled by the
International Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top.
Position the appliance in the desired location. The back should rest against the wall behind it, and
the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply
and drain hoses that can be positioned either to the right or the left sides to facilitate proper
installation.
Levelling the appliance
Once the appliance is positioned for levelling, the height
of the dishwasher may be altered via
adjustment of the screwing level of the feet. In any case,
the appliance should not be inclined
more than 2°.
NOTE:
Only apply to the free standing dishwasher.
Position The Appliance
Free Standing Installation
Fitting between existing carbinets
The height of the dishwasher, 845 mm, has been
designed in order to allow the machine to be fitted
between existing cabinets of the same height in
modern fitted kitchens. The feet can be adjusted so
that correct height is reached.
The laminated top of the machine does not require any
particular care since it is heatproof, scratchproof and
stainproof.
INSTALLATION INSTRUCTIONS