2
Step 3: Set up one Wi-Fi Media Bridge near your gateway
1
Make a wired connection to the Wi-Fi Media Bridge.
1
Connect one end of the Ethernet cable (this is the cable with the yellow connectors) to the
yellow Ethernet port on the back of your Wi-Fi Media Bridge.
2
Connect the other end of the Ethernet cable to your gateway.
2
Connect the power supply adapter.
1
Plug the connector of the electric power supply adapter into the Wi-Fi Media Bridge power
inlet port.
2
Plug the adapter into a nearby power outlet.
3
Turn on the Wi-Fi Media Bridge.
Wait two minutes. The
Power
LED must be
solid
green. If this is not the case, check the
connections you made in the previous steps.
4
After two minutes, check the
Access Point
LED on the front panel. This LED must be green. If
this is not the case:
1
Switch the Wi-Fi Media Bridge to
Access Point
mode using the switch on the back panel.
2
Restart the Wi-Fi Media Bridge by turning the power off and on again.
3
Wait two minutes and check the
Access Point
LED again.
Step 4: Set up one Wi-Fi Media Bridge near your set-top box
1
Make a wired connection to the Wi-Fi Media Bridge.
1
Connect one end of the Ethernet cable (this is the cable with the yellow connectors) to the
yellow Ethernet port on the back of your Wi-Fi Media Bridge.
2
Connect the other end of the Ethernet cable to your set-top box.
2
Connect the power supply adapter.
1
Plug the connector of the electric power supply adapter into the Wi-Fi Media Bridge power
inlet port.
