P-6
Operating Instructions:
Power
Connection
AC Power cord Connection
To connect the power cord to your unit simply plug female side of the power cord into the power cord input
which is on the rear of the unit. Then plug the male side of the power cord to an electric outlet. The AC
power cord supplied purposefully has polarized 2 blades with one wider than the other. If your outlet is not
equipped to handle this type of plug, do not attempt to forcefully plug this AC power cord into the outlet, and
do not alter the plug so that it can fit in the outlet. The only course of action you can take is to find another
outlet which is properly equipped to handle a grounded plug or have an electrician upgrade your electrical
outlet. Be sure that the plug is well connected so that it does not fall out while you are in the middle of
usage. If at any point in time the supplied AC power cord is punctured or damaged replace it with a new
power cord from a local electrician.
Power Switch
After the power cord is connected the unit will still not be powered on until the power switch is pushed into
the “On” position. When turned on, the power indicator will illuminate, to indicate that the unit is indeed
powered on and ready to receive a signal. Once the unit is switched off, the LED will turn off after a few
seconds.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER SWITCH IS IN THE OFF POSITION
AND THE VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
DAMAGE THE AMPLIFIER / SPEAKER. ALWAYS TURN DOWN THE VOLUME PRIOR TO TURNING OFF THE
UNIT. WHEN POWERING ON THE MIXER, FIRST POWER ON THE SIGNAL SOURCE, THEN POWER ON THE
UNIT. ONCE THE MIXER IS POWERED ON, SLOWLY TURN THE VOLUME UP. WHEN POWERING OFF THE
MIXER, FIRST LOWER THE VOLUME, THEN POWER OFF THE MIXER, AND THEN POWER OFF THE SIGNAL
SOURCE.
LED Power Indicator
When the unit is connected to the power cord and switched on, a small LED on the power button should
light up, to indicate that the unit is indeed powered on and ready to receive a signal. Once the unit is
switched off, the LED will turn off after a few seconds.
Input / Output Connections
Connecting Audio Source(s) to the DJ5U Mixer
USB & SD Card Inputs
There are input jacks for a USB flash drive or SD card on the top panel of the DJ5U allowing you enjoy your
music in just a matter of seconds. The USB flash drive & SD Card should not be larger than 32GB. The DJ5U
will only play .mp3 and .wma files from the USB flash drive or SD Card storage devices. Do not attempt to
play any other file types as this will cause the unit to cease playback.
After connecting your USB flash drive / SD Card, set the Channel 2 input selector to USB/SD. You can adjust
the volume using the Channel 2 volume control & the master volume control.
When connecting a USB flash drive or SD Card to the DJ5U, first load the device with all the songs you want
to play. Then simply plug the device into the USB or SD Card input on the top panel of the unit and press
play on the USB / SD controls panel. Use the USB / SD Card controls to play / pause the audio or go to the
next / previous track.
AUX IN Input (1/8” & RCA)
The AUX IN can be used to connect a MP3 player using the 1/8” input on the top panel or a stereo signal
device such as a CD / DVD player using the RCA inputs (on Channel 3) on the rear panel. After connecting
your device to the AUX IN, set the Channel 3 input selector to AUX. You can adjust the volume using the
Channel 3 volume control & the master volume control.
DJ5U
