P-7
1.ONLY PLUG IN AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE VOLUME IS
TURNED DOWN.
2.TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY CAUSE THE UNIT OR ANY
SPEAKERS CONNECTED TO IT TO BE DAMAGED.
3.ALWAYS TURN DOWN THE VOLUME PRIOR TO TURNING THE UNIT OFF OR ON.
●
The Bluetooth word mark and logos are registered trademarks owned by SIG, Inc. and any use of such marks
by Technical Pro is under license. Other trademarks and trade name are those of their respective owners.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient of relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets
the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. The equipment has very low
levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).
●
●
●
1.Audio Input: Connect audio output from your signal source(DVD player, CD player. etc.)
2.AUX IN: Connect your MP3 player here using the 1/8" input.
3.FM ANT: Antenna
4.LED switch: Press this switch to control the lights of the woofers.
Switch this button to "DEMO", the lights is always bright.
Switch this button to "OFF", the lights is off.
Switch this button to "MUSIC", the lights is beating with the music. The stronger of the music, the
brighter of the lights.
5.Dual voltage between 220V and 110V. Pls choose the correct voltage before connect the power cord. In the
USA the voltage should be set to 110V.
6.Power Supply: Only use the power cord provided with the unit to power the unit. When connecting and
disconnecting the power cord, be sure the power of the unit is off. Connect the cord to the rear of the unit and
then connect it to the outlet.
7.LED Output: Send out the LED signal to another speaker box.
8.Speaker Output: Connect the "SPEAKER OUTPUT" to the "SPEAKER INPUT" on another speaker box.
9.Power Switch: Before the unit is powered on, all of the level controls should be turned down all the way. Once
powered on, slowly begin to raise the master volume levels. This will prevent damaging for the
speakers.
