1
- 10
2-WAY MULTISET VRF SYSTEM
Address Settings
1
3. Auto Address Setting
Checking the indoor unit addresses
Use the remote controller to check the indoor unit address.
<If 1 indoor unit is connected to 1 remote controller>
1. Press and hold the
button and
button for 4 seconds or longer.
2. The address is displayed for the indoor unit that is connected to the remote controller.
(Only the address of the indoor unit that is connected to the remote controller can be checked.)
3. Press the
button again to return to normal remote controller mode.
<If multiple indoor units are connected to 1 remote controller (group control)>
1. Press and hold the
button and
button for 4 seconds or longer.
2. “ALL” is displayed on the remote controller.
3. Next, press the
button.
4. The address is displayed for 1 of the indoor units which is connected to the remote controller. Check that the fan of that
indoor unit starts and that air is blown out.
5. Press the
button again and check the address of each indoor unit in sequence.
6. Press the
button again to return to normal remote controller mode.
N
u
mber cha
ng
e
s
to i
n
dicate which i
n
door
un
it i
s
c
u
rre
n
tly
s
elected.
