Techni Mobili RTA-4985, Assembly Instructions Manual

Page: 7 / 21

BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
0
Do a quick inventory to
make sure the package
contains all the parts and
hardware listed in the
assembly instructions.
8
Missing, damaged and
defective parts can be
replaced at no cost to you.
Please refer to the CONT ACT
card included with the product.
8
The replacement parts service
is limited to the continental United
States. If you reside in Hawaii,
�
Puerto Rico, U.S. Dependencies -
or other countries, please contac
the supplier from where the unit
was purchased.
0
If during assembly you
find an issue or need
clarification, please contact
our Customer Service for
assistance. Please refer to
the CONTACT card included
with the product.
9
On each step read the
instructions and analyze
the illustrations
thoroughly before
proceeding to do the
assembly.
C,
Make sure you understand
which hardware will be used on
each step. Using the wrong
size of screw, bolt or pin might
strip the threads or cause
damage to the part in which it
is bein used.
IifT
8
To avoid misalignments,
always leave the screws
loose and tighten them until
all pieces are positioned
correctly.
C,
Do not overtighten or
force the screws as they
might break, strip, damage
the threads of the holes or
get stuck inside the part.
•
8
Sometimes the laminate might cover partially or
entirely the hole on a panel. If there is no visible hole
for the screw, pass and press the tip of your finger
over the area where the hole should be located to feel
the indentation, and once found, carefully pierce the
laminate to reveal the hole underneath.
I
•
G)
If the hole seems too small for the screw, first
make sure you are using the correct size of screw and
that it's been installed in the correct hole. If the hole
still appears to be too small, carefully pierce the
laminate to reveal the hole's actual size.