8
Operation Modes (LED Segment Display)
The following refers to the different modes that are available on this fixture via the LED Segment
Control Panel display. All functions are selectable from the display menu located at the back of
the fixture using the two push buttons, A and B. “A” is on the left, “B” is on the right.
Description of Display and Button Functions
Display Panel Navigation
Use the control panel located on the rear of the fixture to access its settings. Press button “A”
until the desired digit to modify is flashing. Press button “B” to modify the flashing digit. To exit
and save new settings, wait 10 seconds. The three digit display is the DMX512 Start Address
and the P(x,y) display is the selected internal program.
Setting the Start Address for DMX512 Control
1) When a DMX signal is present the fixture will respond to three channels of DMX
beginning with the selected Start Address. If no signal is present the unit will run the
selected internal program.
2) Press button “A” to select a digit to edit, current selection will blink.
3) Press button “B” to change the value of the digit.
4) Valid DMX address are from 1 to 510. Refer below to the DMX 512 Control section for
a more detailed explanation about selecting proper DMX start addresses.
5) To exit this mode, simply wait 10 seconds without pressing any buttons. The display
will stop flashing the new settings will be saved.
