13
CD programming
Up to 20 tacks can be programmed for disc play in any order. You can only
program when a disc is in the closed CD compartment and the device is in
stop mode. Before use, be sure to press the Stop button (2).
[1]
Set in CD mode & stop the CD playback.
[2]
Press the Prog. button (12), Prog. LED indicator (5) will flash.
[3]
Select a desired track by pressing Skip up
or down
buttons
(11/3).
[4]
Press the Prog. button (12) to store the track into memory.
Repeat steps
[3]
and [4]
to enter additional tracks into the memory if
necessary.
When all the desired tracks have been programmed, press
Play/Pause/Power button
(10) to play the song in assigned order.
Press the Stop button (2) to terminate programmed playback.
After program complete, press Prog. button (12) to review the tracks being
programmed.
Press Stop button (2) at CD stop mode again to cancel all programmed
memory until the Prog. LED indicator (5) disappears.
Note:
When you open the CD lid (9) or switch the selector (22) position, the
program memory is erased.
Pressing Stop button (2) twice also terminates the programming
Remark:
AUX-IN and CD are at the same position of function selector (22) CD/AUX.
When to AUX-IN socket (18) a 3.5mm stereo plug is plugged in, the channel
will change to AUX automatically and playback will stop to play. Ensure the
AUX-IN jack (18) is without plugged in 3.5mm stereo plug before playing CD.