12
Shot Lag:
5 sec.
– 60 min.
→
Select and press OK to confirm.
“Short Lag” is the time between the current video and the next video. Set the time
of delay shooting when the camera detects the motion. Within the selected time,
the camera will not record any image or video. It can avoid storing too much of the
same event and saving more storage. (Default is 5 seconds.)
Sensitivity Motion Sensors:
[Low] (default) / [Middle] / [High].
→
Select and press OK button to confirm.
Test the sensitivity and find the correct detection zone for your purpose. Set the
sensitivity of the sensor.
Note:
The temperature can also influence the sensor
sensitivity.
Low
Distance 0-0.20m
For Reference: The distances were tested
with a bird about 3cm in diameter and
10cm in height.
Middle Distance 0-0.23m
High
Distance 0 -0.26m
Target Recording Time
Set the target recording time of the
day. With this option you can
preselect when recordings should
been taken.
As shown in right picture, you can set
the start and stop time. The camera
will work just in the set time slot. In
other time, the camera will keep in
standby state.
Options: [On] / [Off] (default).
→
Press OK to confirm.
Note:
If start time and stop time are the same, the working time is 24 hours.
Language:
(set the language display on screen)
:
[English] / [German] / [Danish] /
[Finnish] / [Swedish] / [Spanish] / [French] / [Italian] / [Dutch] / [Portuguese].
→
Select and press OK button to confirm.
Endless Capture:
[On] / [Off] (default).
→
Select and press OK button to confirm.
If you activate Endless Capture the device will capture photo or/and video,
depending on the mode you choose, until the storage of the MicroSD card is
reached. It is also called loop function.
When the storage is full the recording will move on that means the oldest file
(photo/video) will be deleted, every time a new motion is detected.
Set
Target recording time
Start
：
Stop
：
Hr
：
Min Hr
：
Min
00
00 00 00
MENU Back OK Select
