18G HDMI2.0 EXTENDER SET
OVER CAT5E/6 CABLE
5
WWW.TECHLY.COM
Note
: if the standard resolution of the local display is lower than the
receiver‘s, the unit will output the video with the lower resolution to
ensure video can be shown on both displays.
1
CATx OUT
RJ45 port to connect the CATx IN port of receiver by
CATx cable. It supports 12V PoC to power the receiver.
The orange LED illuminates when there is a valid HDMI
signal input. The green LED illuminates when power is
applied.
2
IR IN
3.5 mm mini jack to connect IR receiver for IR
pass-through.
3
IR OUT
3.5 mm mini jack to connect IR emitter for IR
pass-through.
4
DISPLAY
Type-A female HDMI port to connect HDMI display
device.
5
SOURCE
Type-A female HDMI port to connect HDMI source
device.
6
DC 12V
DC connector for the power adapter connection.
7
EDID
Management
EDID BYPASS
: press the button with paper clip or
other sharp tool to learn the EDID from the remote
display connected to the Receiver’s HDMI out.
EDID COPY Tx/3s
: press and hold the button for 3
seconds to copy the EDID from the local display con-
nected to the Transmitter’s HDMI out.
DEFAULT
: factory default, the source device learns
EDID from the TV which has the lowest resolution.
Press and hold the button while the product is in
turned-off period, and then release the button after 6
seconds of power on can restore the default setting.
