Page 7
4.5 Mounting and removal the WREM 80 ThanGH reader
4.5.1 Reader mounting
The first step is to unscrew all four screws holding the plastic lower cover for placing push
buttons (thereinafter cover) of the
Thangram
panel (
pic. 3a
), then remove the cover.
Cut off
the arrest
located at the bottom side of the cover as shown in the
picture 3c
. Then
place
the reader in desired position
and lead the cables as shown in
picture 3b
, that is
bend the
cable over the top edge of the cover
and lead it behind the cover downwards. It is not
necessary to place the reader in the top position of the cover, it can be placed at any
position of buttons; the cable must be lead similarly as shown in the picture. Then place the
cover back to the panel with cable lead as shown in
picture 3d
. It is handful to lead
appropriate wires
along the walls
of the panel upwards to the
power supply
and
door
lock
contacts, and the rest of the wires
through the back side
of the panel. The last step is
reassembling the cover in the installation box and screwing it in (
pic. 3e
).
4.5.2 Reader removal
When disassembling the reader use a similar procedure as described in the previous
chapter, just remember to
unplug the panel and the reader from the power supply first
!
Pic. 3a
Pic. 3b
Pic. 3c
Pic. 3d
Pic. 3e
