TECHFASS 534771A2, Manual

Page: 20 / 24

www.techfass.com RFID reader module MREM 77 20
Pic.5 a): Inserting cards
7.10.2 Deleting cards
from the reader’s memory
For deleting the cards from the reader module’s memory use following steps:
Step 1 Step 2 Step 3
Read the programming card
for
deleting : the reader goes
into programming mode .
One by one, read the cards
which are to have their
access revoked. About 15 seconds after
deleting the last card the
reader module goes back
into
standard operating
mode .
Pic.5 b): Deleting cards
7.10.3 Deleting cards
„above or below“
If a user loses his ID medium, it is usually impossible to delete the ID from the memory with the procedure described in
the previous chapter, since the medium is no longer available (with an exception of entering the code at the keypad).
Following procedure can be used for deleting such ID. The procedure
requires using an ID medium , which was inserted
right before or right after the ID medium , which should be deleted.
Step 1 Step 2 Step 3
Read the programming card
for
inserting : the reader goes
into programming mode ,
which is indicated by slow
flashing of yellow LED.
Read the programming card
for inserting 5 times in a row;
the reader will go into
Deleting cards “above or
below”
mode indicated by fast
flashing of yellow LED.
Read a card, which is located
in the module’s memory
right
before or right after the card
you wish to delete. After this
step the module quickly
flashes with yellow LED
Step 4 - A Step 4 - B Step 5
For deleting an ID located
right before the ID used in
precious step, read the
programming card for
deleting .
For deleting an ID located
right after the ID used in
precious step, read the
programming card for
inserting .
The reader module goes back
into
standard operating
mode .
Pic.5 c):
Deleting cards “above or below”