PAIRING PROCEDURE:
• Point the remote control to the main unit and using a small screwdriver press the
black switch. The green light will light up.
• Now press any one of the eight buttons on the remote to pair and the green light
should turn off indicating successful pairing.
INSTALLATION:
•
Please read these instructions carefully before installing this product or consult a
professional installer to prevent damage to vehicle and/or system.
• Do not connect to 24VDC or higher voltage system, as this product is designed for a
12VDC battery system. If case you have a larger than 12VDC system, check vehicle
owner ’s manual to determine if a 12VDC output is available and how to connect in
order to use it safely, otherwise, the product will be damaged.
• Find a suitable flat surface near the battery, clean the surface free of dirt and oil and
then affix the unit using provided Velcro strips.
• Disconnect the vehicle battery before starting to install the unit. Detach the negative
(black) cable from the battery terminal and lay it aside. Now securely attach the
positive (red) cable of the WMS unit to the positive terminal of the battery and
negative (black) cable of the WMS to the negative battery cable or vehicle chassis.
• Attach the auxiliary lights/equipment to appropriate terminals and polarities.
• Connect the negative cable to the negative terminal of the battery.
• Insert the two fuses back in their holders and close the covers.
• Install the battery before using the remote (battery is a 12v A23 Alkaline battery).
• Recycle used battery.
Page 3 of 4
MS6210.WIRELESS MANAGEMENT SYSTEM. OWNER'S MANUAL
