- TO test unit under a source of light, keep the
Main Lens on.
- ALWAYS keep Main Lens and Eye Lens cap
on after use
- ALWAYS keep the unit away from any heat
source.
- FAILING to protect the lens will contribute to
the tube intensifier tube to burn out and the unit
will eventually fail.
2.
Operation
Battery Installation:
Unscrew the battery compartments cap, then
install 1 x CR123A battery (not included),
positive (+) side first.
Use:
Press the button of POWER, the green LED
will be on indicator power. The image intensifier
tube will be lighted and will produce a green
image.
Now you can view from the Eye Lens,
remove the Main Lens cover if under a low light
4
to dark situation. Adjust the Zoom by rotating
the front lens by rotating it. To fine tune vision,
adjust the rear lens by rotating it.
Auxiliary IR Lighting:
When observing in a very dark place, press
the IR button to turn on the Auxiliary IR lighting
source.
Turn unit Off:
Press the power button again to turn the unit
off.
Replace Cap:
Once off, ensure you replace the cap over
the lens to protect the unit after use.
3.
Maintenance
- During storage, always ensure the Main Lens
and Eye Lens are covered by the supplied cap.
- Always remove the battery after use and during
any prolonged storage time.
- Keep unit from getting wet
- If unit is used with-in an area with high
condensation, turn unit off and keep off for 5
hours.
- If unit is used with-in an area with high
condensation, turn unit off and keep off for 5
hours before using again.
5
- Do not attempt to open or modify any part of
the unit, doing so will void all warranty.
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’l: +61 2 8832 3200
Fax: 1300 738 500
Made in China
6
