3
1.1 Install antennas for cameras.
1.2 Power on the cameras with power adapters (12V 1A).
1.3 Connect the NVR to Router with an Ethernet cable.
1.4 Plug the mouse (included) into the USB port at the right side of the NVR.
1.5 Power the NVR with its power adapter (12V 2A or with larger output).
1.6 Switch on the NVR Screen button
1.Connect Your System
Right Click the mouse> System Setup, then you will be asked for password, as factory default it
is none. Just leave it blank and Click"OK".
Change the Password
All the wireless cameras in the kit are already matched to the NVR. After the NVR is turned on,
there will be live images of cameras shown on the monitor in seconds.
2. Camera Mounting Spots
3. Extend Wireless WiFi Range
Go to System Admin> User>Set Password. And write down the new password on a note so that
you do not forget it.
2.1 Mount the cameras where within the WiFi range, plug the power adapters into the camera
2.2 The cameras start to stream videos to NVR within 1 minute.
2.3 If it does not display video, the reasons may be: there are too many obstacles in between or
too far from the NVR. Please try to move the cameras closer to the NVR or try to extend the
wireless WiFi range.
3.1 Right Installation and Directions for the Antennas
According to the wireless signal transmission character of antenna, the antennas of cameras
should overlap or parallel to NVR WiFi wireless signal, as pictures shown below:
wireless signal, as pictures shown below:
should overlap or parallel to NVR WiFi
Correct
Wrong
HD LCD SCREEN
screen
POWER
HDD
HD LCD SCREEN
screen
POWER
HDD
