1.
HARDWARE
12
1.4 System setup
PLEASE FOLLOW THESE INSTRUCTIONS FOR A PROPER SYSTEM SETUP
BEFORE USING MAGIC GLASS.
1. Put the placemat on the table, by
aligning the underside to the edge of
the table.
2. Open the sensor support arms (F) up to the maximum width. Make sure
the orientation of the sensors is parallel to the computer. If necessary, adjust
them using the lever at the base of the sensor.
3. For limited repositioning of the Magic Glass system: wrap the headset
cables around it and insert them inside the frame (A); then close the sensors
support arms (F). Lift the system by holding the support to the sides.
4. For more extended repositioning of the Magic Glass system it is
recommended to reuse the original packaging.
