06/29/17
ICA-202D OPERATION AND INSTALLATION MANUAL
Page 18 of 32
Call Tone Level:
The Call Tone signal comes through the Operator’s speaker.
This adjustment should be made after Communications levels are set.
The Call Tone level has three Steps, "HI", "MED", "LO"
Setup is accomplished by activating the ‘Call Tone’ by pushing the ‘Call’ Switch.
Select a suitable Call Tone level.
Privacy Tone Level:
(Note: the Privacy and Page Preannounce Tones share the same "Level" setting)
The Privacy Tone signal comes through the Remote speaker.
This adjustment should be made after Communications levels are set.
The Privacy Tone level has three Steps, "HI", "MED", "LO"
(The
Privacy Tone must be enabled
, "P-TONE-ENABLE" tied to COMMON)
Setup is accomplished by performing a sequence that causes a Privacy Tone
First push and release the ‘Shut Off’ Switch, then push the ‘Activate/On’ Switch.
The Privacy Tone will sound briefly. If your system does not have a push to ‘Activate/On’
Switch the Privacy Tone will sound briefly every 18 seconds when the Intercom is active.
Select a suitable Privacy Tone level.
Page Pre-announce Tone Level:
(Note: the Privacy and Page Preannounce Tones share the same "Level" setting)
The Page Pre-announce Tone comes through the Page Line Level Output
The Privacy Tone level has three Steps, "HI", "MED", "LO"
The
Page Preannounce Tone
, (Jumper Option)
must be "ON"
Press the Page Switch; the Preannounce tone will sound
Select a suitable Page Pre-announce Tone Level
Paging Control:
Paging is Handled similarly to PTT, with additional Jumper Options:
There is a 200ms Pre-Announce Tone
ON
There is No Pre-Announce Tone
OFF
The (Internal) Remote Speaker Amplifier is Disabled during a Page
MUTE
The (Internal) Remote Speaker Amplifier is Enabled during a Page
UNMUTE
