14
Settings – This function is used to activate the window sensor (possible after sensor registration) and set the
delay time.
When the pre-set delay time is over, the main controller sends the information to the actuators forcing them to
close. The time setting range is 0-30 minutes. Example:
Delay time is set at 10 minutes. When the window is opened, the sensor sends the information to the main
controller. If the sensor sends another information that the window is open after 10 minutes, the main controller
will force the actuators to close and the heating in the zone will be disabled.
NOTE
If the delay time is set at 0 minutes, the message forcing the actuators to close will be sent immediately.
3.
OPERATION MODES
This function enables the user to activate one of the following operation modes in a given zone.
Normal mode – the temperature depends on the selected schedule.
Holiday mode – the pre-set temperature depends on the ''Temperature settings'' parameter
(Menu>Zones>Temperature settings>Holiday)
Economical mode – the pre-set temperature depends on the ''Temperature settings'' parameter
(Menu>Zones>Temperature settings>Economical temp.)
Comfort mode – the pre-set temperature depends on the ''Temperature settings'' parameter
(Menu>Zones>Temperature settings>Comfort temp.)
4.
EXTERNAL SENSOR
It is possible to connect an external sensor to the controller to be able to view current outside temperature on the zone
screen. The external sensor is not involved in temperature control. In order to register the sensor, follow these steps:
Select registration option in L-4 WiFi
Press the registration button on the sensor
Once the module has been registered, the controller will offer new options - reading the radio signal, checking the battery
level and performing sensor calibration.
Calibration should be performed while mounting or after it has been used for a long time, if the external temperature
displayed differs from the actual temperature. Calibration setting range is from -10
O
C to +10
O
C with the accuracy of 0,1
O
C.
5.
FLOOR
PUMP
L-4 WiFi controls the pumps - it enables the pump after the delay time if the temperature of any zone is too low. When
all the zones reach their pre-set temperatures, the controller disables the pump.
The user may:
- choose the device connected to the built-in voltage-free contact (default setting - floor pump) by selecting ‘Built-in
contact’.
