1. UNPACKING
EO18-12010
1.3 Tapes
1- 2
1.3 Tapes
Remove all the tapes from the POS terminal.
1.4 Notes for Installation
WARNING!
1. Care must be taken not to get your fingers caught between the LCD Frame and the POS terminal
when bending the display backward.
2. DO NOT raise the LCD Frame while the Front Cover is not in position. When the LCD Frame is
raised at right angle (90
°
) or more, the LCD may fall under its own weight, and your fingers may be
caught.
CAUTION!
1. When removing the protective film from the display surface, please be sure to do it slowly. If it is
done quickly, static electricity may generate, and the TFT may be damaged.
2. When installing the POS terminal, take the following precautions. Failure to do this may cause fire,
electric shock, or injury.
(1) Avoid locations where it is subject to the following:
•
Direct sunlight
•
High temperature, high humidity
•
Rapid change in temperature
•
Excessive vibration
•
Dust
(2) Keep away from any devices that emit magnetism or electromagnetic wave.
(3) Keep away from flame or moisture.
(4) Be sure to place the POS terminal on a level and stable surface.
1. Place the POS terminal on a level surface.
2. Provide a minimum space to the left, right, front and rear of the POS terminal for proper cooling.
(The unit has air vents and a fan on the front and left. Spaces should be provided to prevent the air vents
from being blocked and the air flow from being obstructed.)
NOTE: A fan is provided on these sides. Do not prevent the ventilation of the fan
.
80 mm
(See
NOTE
.)
80 mm
80 mm
80 mm
See
NOTE
.