9
When Using Portable LP Cylinders:
Connector must comply with the Standards for
Connectors for Outdoor Gas Appliances
and Manufactured Homes, ANSI Z21.75 /CSA 6.27
, and suitable for outside installation.
1.
Inspect the gas hose prior to using the grill each time. If there is evidence of exces-
sive abrasion or wear and tear or if the hose is cut, it must be replaced before using
the grill with a TEC specified regulator/hose assembly.
2.
Use only approved 20 lb LP cylinders that have a collar to protect the cylinder valve
and are in good condition.
3.
Never fill the cylinder beyond 80% full.
4.
Keep the ventilation openings of the cylinder enclosure (i.e. cabinet, island, etc) free
and clear from debris.
5.
Be sure to set the cylinder upright (so that the cylinder valve is at the top) and fasten
it securely inside the grill cabinet or island using the provided tank strap restraints.
6.
Follow the procedure in the manual carefully for connecting and disconnecting the
cylinder to the grill.
7.
Ensure visibility of and support for the connector.
8.
Maximum length of the LP gas hose shall be 6 ft (1.82 m).
9.
Always turn off the gas at the valve of the cylinder when the grill is not is use.
10.
Never store additional or empty propane cylinders in the grill cabinet or island or in
the vicinity of this or other appliances.
11.
Do not store your grill indoors unless you disconnect and remove the cylinder.
12.
Cylinders must be stored outdoors, out of reach of children, and must not be stored
in an enclosed area.
13.
Place the dust cap that is provided with the cylinder on the valve of the cylinder
when not in use.
Your LP Gas
Cylinder Must
Be
:
1.
Constructed and marked in accordance with the
Specifications for LP
-
Gas Cylinders
of the U. S. Department of Transportation (D.O.T.) or the National Standard of Can-
ada,
CAN/CSA
-
B339, Cylinders, Spheres and Tubes for Transportation of Danger-
ous Goods; and Commission,
as applicable.
2.
Equipped with a listed overfill protection device as well as a standard Type 1 valve
connection compatible with the LP regulator/hose assembly provided with the grill.
LP GAS CYLINDER SAFETY
LP GAS CYLINDER REQUIREMENTS
Summary of Contents for Patio FR series
Page 2: ...II...
Page 4: ...IV CROSS SECTION VIEW PATIO SERIES GRILLS FIGURE 1...
