11
Safety, warnings and troubleshooting information
•
Follow all safety instructions provided when used with any TEC products.
•
Do not operate the gauge if any liquid gets inside the gauge.
•
If the inside of the gauge gets wet, immediately turn off the gauge and remove the
batteries.
•
Leave the battery compartment cover off to allow for drying.
•
Dry the batteries with a towel and allow the batteries to air dry for at least 12 hours.
•
Allow the gauge to air dry for at least 12 hours before inserting the batteries and
powering back on.
•
If a liquid gets inside the pressure ports, contact TEC at 612-827-1117.
•
Do not attempt to dry any of the electrical connectors with a Q-Tip or similar item.
Lithium Ion battery safety and warnings
•
Do not leave the batteries in direct sunlight or in an area heated by sunlight. The
battery could generate heat, smoke or flames.
•
Do not use the batteries when there is rust present, the batteries have a bad smell
or if the batteries are damaged in any other way.
•
Keep the batteries out of the reach of children and animals.
•
If fluid from the battery leaks out and makes contact with skin, wash with soap
and water. The fluid may cause irritation. If that happens please see a doctor
immediately.
•
Do not expose the batteries to extreme heat, flames or liquids.
•
Do not modify or disassemble the batteries as this could result in leakage or
explosion.
•
When replacing the batteries in the gauge, use identical, fresh batteries.
•
Always charge both batteries at the same time.
Touch screen use and care
•
A screen protector is included with the DG-1000. Replacement screen protectors
can be purchased from TEC.
•
To clean the screen, use the microfiber cloth included with the DG-1000.
•
Do not clean the screen with flux, water, acetone, ethanol, isopropyl alcohol,
toluene or ammonia (glass cleaner).
Introduction
The DG-1000 is a two channel low pressure gauge that is intended to be used with
equipment manufactured by The Energy Conservatory, or as a manometer.
