14
Revised 11/04 -- Z21.89b-2004/CSA 1.18b-2004
Cleaning and Storage
CAUTION:
ALWAYS ALLOW THE GRILL TO COOL
BEFORE CLEANING. DO NOT ALLOW WATER TO MAKE
CONTACT WITH THE BURNER SURFACE, AT ANY TIME.
Drip Tray
Remove soiled foil and rinse the Drip Tray with soap and
water. Re-cover the Drip Tray with foil.
Heat Shield
Remove soiled foil and re-cover. If necessary, the Heat
Shield may be removed for further cleaning with soap
and water.
Cooking Grid
Leave the Cooking Grid in place for 5-10 minutes while
the Burner is on HIGH and the hood OPEN. The
Cooking Grid may also be removed and cleaned with a
brass or stainless steel bristle brush and soapy water.
Standard oven cleaners may be used for deeper cleaning.
Rinse the Cooking Grid thoroughly with clean water
before using.
Storage and Transport
Caution: Always allow the grill to cool before handling
or storing. Place the Cooking Grid in the Drip Tray
when transporting. Always store the grill in its upright
cooking position. Storage of this appliance indoors is
permissible only if the cylinder is disconnected and
removed from teh appliance. Cylinders must be stored
outdoors, out of the reach of children, and must not be
stored in a building, garage or any other enclosed area.
Maintenance
The Cherokee requires very little maintenance. However,
a periodic inspection of orifice openings and venturi
inlets to clear obstructions to gas flow is recommended.
Burner Head
The most important way to maintain the performance of
the Infra-red Burner is to operate the grill on HIGH for
at least 5 minutes after each use.
This procedure will leave some ash on the surface of the
Burner Head. If it accumulates in excessive amount, it
will clog the small ports in the ceramic surface. To
prevent this blockage, remove the Cooking Grid and
vacuum the burner surface with a low-suction vacuum
cleaner or sweep away ashes with a soft bristle brush,
every six months, or as necessary. When performing this
procedure be careful not to scrape or strike the ceramic
with the suction device, which may damage the ceramic.
The ceramic surface of the Burner is fragile and must be
handled carefully.
WARNING:
EACH GAS ORIFICE MUST BE PROPERLY
LOCATED ON THE ORIFICE BRACKET, ATTACHED TO
THE VENTURI ON THE BURNER ASSEMBLY. AN
IMPROPERLY LOCATED ORIFICE CAN LEAD TO
BODILY INJURY AND PROPERTY DAMAGE. THE
PROPER LOCATION IS SHOWN IN FIGURE 10.
Figure 10.
Combustion Components
Cleaning and Maintenance
continued
Summary of Contents for Cherokee CH-10SS
Page 2: ...Cherokee Expanded View...
